FAQ Archive
GPSController FAQs - Page 305
Browse older support questions without loading full answer pages into the archive.
FAQ
Can I use the same GPS tracker on both a mower and a crew truck?
No, not optimally. Mowers experience constant vibration and are often stored in metal enclosures, requiring ruggedized devices with external antennas. Crew truck trackers focus more on driver behavior and route adherence...
Read full answer ->FAQ
How accurate is GPS for tracking landscaping crews in neighborhoods with tree cover?
While GPS accuracy is typically within 5-10 meters, the real issue is update delay. In areas with poor cell service or under heavy tree canopies, location data can be 5 to 15 minutes old, making real-time crew tracking u...
Read full answer ->FAQ
When should a school district replace its GPS controller for passenger counting?
Consider replacement when discrepancies affect more than 10% of daily routes, when historical reports can't be trusted for incident review, or when your current vendor can't guarantee sub-second sensor-to-cloud data sync...
Read full answer ->FAQ
What causes passenger count data to desynchronize from GPS location data?
The primary cause is usually a latency mismatch where the sensor counts in real-time, but the GPS controller processes and transmits location and occupancy data in separate, unsynchronized batches. This issue worsens in...
Read full answer ->FAQ
Can a GPS tracking system work if the passenger sensor fails?
Yes, the location tracking continues to function, but the system loses all occupancy intelligence, creating major compliance risks as states increasingly require logged passenger manifests alongside location history for...
Read full answer ->FAQ
How accurate are passenger count sensors on school buses?
Modern infrared or weight-based sensors are 98-99% accurate under ideal conditions, but accuracy decreases significantly when integrated with older GPS controllers that sample data too slowly, missing rapid boarding and...
Read full answer ->FAQ
When should a plumbing company replace their entire GPS tracking system?
When dispatchers ignore the GPS map and rely on phone calls to locate technicians, and when job completion data requires manual entry instead of flowing automatically from geofence alerts. This indicates a core workflow...
Read full answer ->FAQ
How does inefficient GPS tracking increase overtime costs for plumbing fleets?
Delayed or inaccurate location data leads to inefficient routing, sending vans crisscrossing territories. Technicians end up driving extra hours across town to finish jobs that could have been grouped geographically, pus...
Read full answer ->FAQ
How can signal delays in GPS tracking cause compliance issues for plumbing companies?
Signal delays create discrepancies between actual job times and recorded data. If GPS logs show a van arriving at 10:05 but the customer signed the work order at 9:50, this 15-minute discrepancy can void service guarante...
Read full answer ->FAQ
What's the biggest GPS tracking mistake for a plumbing company fleet?
Using consumer-grade or simple GPS loggers instead of integrated fleet tracking systems. Basic trackers lack real-time engine-off detection and integration with dispatch software, preventing dispatchers from knowing if a...
Read full answer ->FAQ
What happens when GPS signal is lost during driver tracking?
Good systems use last-known-status logic and fill gaps with other sensors like engine data from OBD ports before marking time as 'unverified.' Without this multi-source approach, signal loss in tunnels or urban canyons c...
Read full answer ->FAQ
How does GPS software handle different pay rules for different drivers or locations?
Systems can handle different pay rules but this adds complexity and risk. A common failure occurs when the system defaults to the most common rule set, potentially getting overtime or break penalties wrong for subsets of...
Read full answer ->