FAQ Answer
What should I do if both my main and spare key fobs stop working?
Related FAQs: When should you stop comparing pricing and start redesigning your tracking system?
Support Context
Why this answer matters
This FAQ is sourced directly from our support database. It helps teams deploy GPSController faster, reduce onboarding friction, and understand platform compatibility for real-world fleet operations.
Answer summary
If both fobs fail, you're likely facing a vehicle antenna module or body control unit issue, which moves beyond a quick fix and requires professional diagnosis and repair.Related FAQs: When should you stop comparing pricing and start re...
Who it helps
- Fleet managers validating device compatibility
- Operations teams planning installation workflows
- Support teams troubleshooting GPS platform setup
- Platform-ready guidance for GPS devices and integrations
- Clear operational steps for setup and troubleshooting
- Updated answer content aligned with live deployments
Key terms
GPS tracking, fleet management, device installation, protocol setup, connectivity validation, and GPSController compatibility.
Implementation checklist
- Confirm device model, firmware, and protocol version
- Validate SIM coverage and network band support
- Map required sensors and IO configuration
- Test live device reporting before full rollout
Ideal use cases
- Fleet tracking, cold-chain monitoring, and asset recovery
- Compliance audits and safety analytics
- Fuel monitoring and route optimization
- Driver behavior insights and incident response
How to apply this
Collect device specs and confirm integration requirements.
Align configuration with GPSController platform rules.
Run a pilot test and scale across the fleet.
Related FAQs
Can signal jammers affect remote immobilizer functionality?
Yes, GSM jammers can block the command signal to the immobilizer. However, a well-configured tracker should log the jamming attempt and trigger secondary alerts...
What are the signs that I need to replace my GPS tracker immobilizer?
You should consider replacement when immobilizer delays become consistent, hardware diagnostic reports show relay fatigue, or when the system can't meet updated...
How does network latency affect immobilizer performance in India?
In India's varied cellular landscape, network latency on 2G fallback bands can delay immobilization commands by 45-90 seconds, which is critical during theft si...
What causes remote engine immobilizer failures in GPS trackers?
Remote engine immobilizer failures are typically caused by voltage drops from aging vehicle batteries, signal jitter in urban areas, cellular network latency (e...
When is a car key fob beyond DIY repair?
It's beyond DIY when the circuit board is damaged, the internal transponder chip is broken, or programming is required. At that point, you need a GPS controller...
How do I reset my car remote after changing the battery?
Many fobs re-sync automatically if you press a button near the vehicle. If not, consult your manual for a resync procedure—it often involves turning the ignitio...
Answer Snapshot
If both fobs fail, you're likely facing a vehicle antenna module or body control unit issue, which moves beyond a quick fix and requires professional diagnosis and repair.Related FAQs: When should you stop comparing...